Grill High Severity
GAS-SMELL Appliance Error Code

Viking Grill GAS-SMELL Error: Gas leak detected

Viking Grill GAS-SMELL: Gas Odor Is a Safety Emergency If you smell gas near your Viking grill, stop everything and close the tank valve now. Turn it clockwise until it stops. Do not press the igniter, do not flip any light switches, and do not use your phone until you are away from the grill. […]

Quick Assessment

Answer to continue safely

Is it safe to keep using?

No. DO NOT use the grill until the leak source is identified and repaired. This is a fire and explosion hazard. Close the tank valve and keep it closed until the repair is complete.

Can I reset the code?

No. There is no reset for a gas leak. The leaking component — hose, fitting, or valve — must be repaired or replaced before the grill is used.

When to stop immediately?

Stop if you notice: IMMEDIATELY — close tank valve and do not use the grill, If smell is inside a building or garage, evacuate and call your gas provider.

Symptoms You May Notice

Rotten egg smell near the grill

Propane and natural gas contain mercaptan, an additive with a distinct rotten egg or sulfur odor. Any detection of this smell warrants immediate action.

Gas smell when grill is off

Odor present even when all knobs are in the OFF position.

Unusually strong gas smell during normal operation

More pronounced than the brief whiff of gas when a burner first lights.

Possible Causes

1

Loose regulator or hose connection

A fitting that is not fully hand-tightened allows gas to seep from the connection.

DIY Possible
2

Damaged, cracked, or aging gas hose

Propane hoses degrade over time from UV exposure, heat cycles, and age. Cracks allow gas to escape.

DIY Possible
3

Faulty or sticking burner valve

A burner valve that doesn't fully close allows gas to bleed through even in the OFF position.

Requires Professional
4

Damaged tank valve or fitting

The valve on the propane tank itself is leaking.

Requires Professional

Safe Checks You Can Do

These checks are safe for homeowners. No disassembly required. Do not remove panels or access internal components.
  1. 1

    IMMEDIATELY close the tank valve

    Turn the propane tank valve clockwise until it stops. Do not attempt to light the grill. Do not operate any other electrical switches or appliances nearby. Move away from the grill.

    If the smell is very strong or you cannot locate its source, leave the area and call your gas provider.

  2. 2

    Do not use any ignition sources

    Do not press the igniter, use a lighter, or operate any electrical switches (lights, phone chargers) in the immediate area until the leak is identified and repaired. Gas can accumulate in low areas.

    Propane is heavier than air and will pool at ground level. Ventilate the area by moving away, not by fanning.

  3. 3

    Perform a soapy water leak test (tank valve closed first)

    Only after the tank valve is fully closed, mix dish soap with water. With the tank valve still closed, brush the solution on the regulator connection, hose body, and hose-to-grill fitting. Open the tank valve slowly and watch for bubbles. A bubbling location is the leak point.

    Do this test outdoors in open air, away from any ignition sources.

When to Call a Professional

Contact a qualified technician if:

  • Soapy water test shows bubbles at the tank valve itself — replace the tank
  • Bubbles at a burner valve fitting — valve must be replaced by a technician
  • Hose shows cracking, discoloration, or is more than 5 years old — replace the hose
  • Leak cannot be located but odor persists — professional gas leak inspection required

Need Professional Help?

Find qualified technicians in your area for proper diagnostics and repair.

Grill Repair Service Schedule Appointment